Thiết bị đo, kiểm soát pH và ORP online, Hanna- Mỹ, HI9912

Liên hệ
Mã sản phẩm: 855
Liên hệ trực tiếp

Thông số kỹ thuật:

Hãng sản xuất: Hanna- Mỹ

Xuất xứ: Rumania

Bảo hành: 12 Tháng

Thang đo:  pH 0,00 đến 14,00 pH

                    ORP 0 đến 1000 mV

Độ phân giải: pH 0,01 pH

                        ORP 1 mV

Độ chính xác @ 20 °C: pH: ± 0,02 pH

                                        ORP: ± 5 mV

Hiệu chuẩn: Bằng tay, hai điểm cho đo pH và điểm 1 cho ORP, qua vít chuẩn

Điểm cài đặt:, lựa chọn từ 6,00 đến 8,00 pH và từ 500 đến 900 mV

Tỷ lệ kiểm soát hai độc lập điều khiển: pH từ 0,0 đến 2,0 và ORP từ 0 đến 200 mV với hai chu kỳ thời gian riêng biệt từ 0 đến 90 giây

Báo động chuyển tiếp liên lạc có thể được cấu hình như thường mở hoặc thường đóng (cô lập sản lượng tối đa 2A, tối đa 240V, điện trở tải, 1.000.000 đột quỵ). Báo động này được kích hoạt nếu độ pH thay đổi nhiều hơn so với khoảng thời gian người sử dụng lựa chọn (0 2 pH), và / hoặc ORP thay đổi nhiều hơn so với khoảng thời gian người sử dụng lựa chọn (0 đến 200 mV) từ điểm đặt hoặc do quá liều

Liều Thiết bị đầu cuối của hai bộ thiết bị đầu cuối độc lập (115 đến 240V, max.2A, 1.000.000 đột quỵ) được kích hoạt bất cứ khi nào pH vượt quá điểm thiết lập pH hoặc ORP giảm xuống dưới điểm thiết lập mV

Nguồn cung cấp: ± 10% 115 VAC hoặc 230 VAC, 50/60 Hz

Môi trường hoạt động: -10 đến 50 ° C (14 đến 122 ° F), RH max 95% không ngưng tụ.

Kích thước: 221 x 181 x 86 mm

Trọng lượng: 1,6 kg

  HI 9912

HI 9912 is a pH and ORP controller specially designed for pool sanitization.

Two separate set points can be adjusted by the user from 6 to 8 pH and 500 to 900 mV. The relays are activated when the pH exceeds or the mV falls below the relevant set point. HI 9912 accepts any pH and ORP electrode ending in a universal BNC connector. Two independent terminals provide for pH and ORP matching pin/ ground probes to extend electrode life and eliminate interference.

HANNA’s proportional control allows considerable savings by minimizing the use of chemicals. The settings are made through independent time cycles adjustable from 0 to 90 seconds and two proportional bands from 0 to 200 mV and 0 to 2 pH. Two pumps or electrovalves can be wired directly to the controller and be powered through the terminal.

The HI 9912’s alarm is activated when measurements exceed the operator-adjustable thresholds of 50 to 250 mV or 0.5 to 2.5 pH. Should the two max dosing periods of 1 to 10 minutes be exceeded an alarm is activated to signal the abnormality. The alarm is alterable in a normally-closed or a normally-open state and can be turned off during maintenance. A pools status can be ascertained from a distance through dosage and alarm LED’s.

HI 9912 comes with extractable terminal modules for quicker and safer wiring. The wiring compartment is protected behind a fire-retardant ABS removable panel.

 

 

Order Information:

HI 9912 is supplied complete with instructions.

Range pH 0.00 to 14.00 pH
  ORP 0 to 1000 mV
Resolution pH 0.01 pH
  ORP 1 mV
Accuracy @ 20°C pH ±0.02 pH
  ORP ±5 mV
Input Impedance   1012 Ohm
Calibration   manual, two points for pH and 1 point for ORP, through trimmers on the front panel
Setpoint   two, selectable from 6.00 to 8.00 pH and from 500 to 900 mV
Proportional Control   two independent controls: pH from 0.0 to 2.0 and ORP from 0 to 200 mV with two separate time cycle from 0 to 90 seconds
Alarm Contact   relay can be configured as normally open or normally closed (isolated output max. 2A, max. 240V, resistive load, 1,000,000 strokes). The alarm is activated if pH varies by more than the user selectable interval (0 to 2 pH), and/or ORP varies by more than the user selectable interval (0 to 200 mV) from the set points or due to overdosage
Dosing Terminals   two sets of independent terminals (115 to 240V, max.2A, 1,000,000 strokes) are activated whenever pH exceeds the pH set point or when ORP falls below the mV set point
Power Supply   ±10% 115 VAC or 230 VAC; 50/60 Hz
Environment   -10 to 50°C (14 to 122°F); RH max 95% non-condensing
Dimensions   221 x 181 x 86 mm (8.7 x 7.1 x 3.4’’)
Weight   1.6 kg (3.5 lb.)

XEM ĐẦY ĐỦ

Bình luận.

Reviews

There are no reviews yet.

Be the first to review “Thiết bị đo, kiểm soát pH và ORP online, Hanna- Mỹ, HI9912”

Email của bạn sẽ không được hiển thị công khai. Các trường bắt buộc được đánh dấu *